■ “Air-purging” Without Problems or Loss Reagents.
Turn the operation mode selector to the right at a 90˚ angle. A maker and the
discharge tube will indicate the right position. Remove (purge) the air by
several pumping actions.
No reagent is lost as you are pumping in a closed circuit.
■ NO More Spills : NO Reagent Loss.
Residual reagent to be dispensed is not lost when working with the TITREX 2000.
For environmental and cost reasons reagents can be transfered easily without loss.
Turn the operation mode selector 90˚ to the right and the residual amount
inside the cylinder will be pumped back into the bottle or container.
■ Safe & Secure Restposition.
By turning the operation mode selector by 180˚ all liquid in the discharge tube
flows back into the bottle. It is almost impossible for any leakage to occur
when it is in that position.
The TITREX 2000 is completely shut down and no accidental discharge will occur
by inadvertently moving the position.
This is clearly indicated by the position of the tube and the setting of the
operation mode.
■ Auto-Calibration.
The permanent calibration of the TITREX 2000 is adjusted to water at 20˚.
For liquids of different viscositiesd / densities the TITREX 2000 can be easily
recalibrated by pushing the button “O/CAL”- just follow the detailed
instructions of the manual.
■ Parctical & Fast Pre-selection of Volumes Needed for Titrations.
Just push the key “DOS” and you can pre-select the burette-volume for your
titrations.
By watching the display you always can control the volume of liquid, that
you suck-in to the burette cylinder. Press the button “zero” and titration
can start immediately.
It could not be quicker, handier and more accurate than with a glass burette
and more sensitive than with a motor dirven burette.
The key “MEM” (memory) helps to avoid complicated calculations.
■ Up to 500 Data Sets maybe stored in the memory and are available for data
evaluation on PC or Printer.
Together with the “WITOLINK” software specific evaluations are possible
: Option.
■ “Auto-Off” power after 3 minutes, and a Flashing Alarm for the Battery Changing.
■ 운전중에 “몸체가 상·하로
움직이지 않는” 유일한 Digital buret임.
주요 특징 (Main Features)
* TITREX 2000™은 일반 유리 Burette 보다 변환점이 빠르고 민감함. 또한 Motor Burette
보다 가격이 저렴함.
* Witeg TITREX 2000™ 만이 Titrating 과정중에 몸체가 상하로 이동하지 않는 유일한
Digital Burette임.
* 분주 속도는 손잡이 (Hand Wheel)를 돌리는 속도에 따라 무단 가감속됨. 왼손/오른손
겸용.
* 최종 사용후 3분 경과시 자동 Cut-off.
* 사용하고 남은 뷰렛내의 시약을 병속으로 완전회수.
* 기본형과 정밀형 2-모델, 정밀형은 미량 (0.**ml)조절용 Fine Controller 장착.
* 기구내에서 기포 완전제거 “Air-purging”
* 자동 보정/메모리 기능.
주요 규격 (Main Specifications)
* ‘CAL’ Button에 의한 쉬운 보정 “Auto-Calibration
* 약품손실 zero(0)
* 작동온도 10 - 40℃, 보관온도 최대 60℃
* Battery 충전식 AC/DC 겸용.
* Range : 0 ~ 50 (0.01) ml, ±0.1% 이내
* Complete Set로 공급됨 : 2 Lit. 갈색병, 재충전식 Battery, AC 220 V Adapter 및
Screw connect, Adapters
|